Labo Élec

electrical lab simulator
0 1 / 20

Exercise from the chapter "Ohm's law & resistance"

The leads

Level 1 of 5 · Skills: Build

Statement

This time only two leads are available (counter in the palette).

Drag a lead from the +V terminal of the supply to the big hole of the left leg of R1 (E4), and a lead from COM to the hole of the right leg (G4).

The colour is chosen automatically: red for +, black for −.

2 hints from Bastaya available in the lab
Solution

The lead plugs into the big hole of the leg: that hole is a circuit node, the leg and the plug share its potential.

Course sheet of the chapter : Ohm's law & resistance

This chapter is covered by the paths: Discovery, General electricity

Other exercises of the chapter

Simulated time00:00:00
Q = I·t-
W = P·t-

Workbench

Circuit diagram CEI 60617

How does it work?

The perfboard: each big hole is a circuit node. You push a single leg of a component (resistor, lamp...) into it. The 4 small holes around it are connected to it: that is where chips and leads plug in.

  1. Drag a component onto the board: it snaps onto the grid. R rotates it.
  2. To join neighbouring big holes, click Jumper chip in the palette (or C) then drag on the board: a line of chips is laid at once. Bridged holes become a single node.
  3. For long links and for the power supply (placed next to the board), drag a lead from one big hole to another (or to a terminal).
  4. As soon as a loop is closed, the circuit is solved in real time (Ohm + Kirchhoff) and the diagram follows.
  5. Zoom with the wheel (or + / −, two-finger pinch); drag the background to pan, 0 fits the board. The + buttons around the board add a row or a column.

Del delete · R rotate · C chip brush · Esc cancel · wheel zoom · drag the background to pan

Confirmer

Importer un montage

Export