Labo Élec

electrical lab simulator
0 1 / 20

Exercise from the chapter "Resistor networks"

Two-wire line

Level 3 of 5 · Skills: Analyse

Statement

Load R1 = 10 Ω is supplied at 12 V through two copper wires F1 and F2 of 50 m and 1.5 mm² each (their resistance is shown on the board).

What voltage does R1 receive?

Parametric exercise: the values change with every draw; these are one example.

2 hints from Bastaya available in the lab
Solution

Each wire is 567 mΩ; I = 12 / (2 × 0.5667 + 10) = 1.08 A; U1 = 10.8 V. The line "eats" 611 mV per wire.

Course sheet of the chapter : Resistor networks

This chapter is covered by the paths: General electricity

Other exercises of the chapter

Simulated time00:00:00
Q = I·t-
W = P·t-

Workbench

Circuit diagram CEI 60617

How does it work?

The perfboard: each big hole is a circuit node. You push a single leg of a component (resistor, lamp...) into it. The 4 small holes around it are connected to it: that is where chips and leads plug in.

  1. Drag a component onto the board: it snaps onto the grid. R rotates it.
  2. To join neighbouring big holes, click Jumper chip in the palette (or C) then drag on the board: a line of chips is laid at once. Bridged holes become a single node.
  3. For long links and for the power supply (placed next to the board), drag a lead from one big hole to another (or to a terminal).
  4. As soon as a loop is closed, the circuit is solved in real time (Ohm + Kirchhoff) and the diagram follows.
  5. Zoom with the wheel (or + / −, two-finger pinch); drag the background to pan, 0 fits the board. The + buttons around the board add a row or a column.

Del delete · R rotate · C chip brush · Esc cancel · wheel zoom · drag the background to pan

Confirmer

Importer un montage

Export