Labo Élec

electrical lab simulator
0 1 / 20

Exercise from the chapter "Kirchhoff's laws"

Reproduce a bridge

Level 5 of 5 · Skills: Build

Statement

This Wheatstone bridge is neither series nor parallel: the automatic diagram cannot draw it, so the author drew it opposite.

Reproduce it on the board with five resistors (100, 200, 300, 400 and 500 Ω). The checker compares the electrical structure, not the position.

3 hints from Bastaya available in the lab
Solution

The engine solves the bridge by nodal analysis; the checker verifies graph isomorphism (values included).

Course sheet of the chapter : Kirchhoff's laws

This chapter is covered by the paths: General electricity, Measurement prep

Other exercises of the chapter

Simulated time00:00:00
Q = I·t-
W = P·t-

Workbench

Circuit diagram CEI 60617

How does it work?

The perfboard: each big hole is a circuit node. You push a single leg of a component (resistor, lamp...) into it. The 4 small holes around it are connected to it: that is where chips and leads plug in.

  1. Drag a component onto the board: it snaps onto the grid. R rotates it.
  2. To join neighbouring big holes, click Jumper chip in the palette (or C) then drag on the board: a line of chips is laid at once. Bridged holes become a single node.
  3. For long links and for the power supply (placed next to the board), drag a lead from one big hole to another (or to a terminal).
  4. As soon as a loop is closed, the circuit is solved in real time (Ohm + Kirchhoff) and the diagram follows.
  5. Zoom with the wheel (or + / −, two-finger pinch); drag the background to pan, 0 fits the board. The + buttons around the board add a row or a column.

Del delete · R rotate · C chip brush · Esc cancel · wheel zoom · drag the background to pan

Confirmer

Importer un montage

Export